DIY Phone Lamp
Old rotary phones look really cool, but we don’t see too many people using them. That’s why we made this sweet phone lamp. It turns that old retro phone into something useful! Find out how to make your own rotary phone lamp.
Materials you need to make a phone lamp:
Retro telephone
Curved metal rod (we used an old lamp part) and hex nut
2 pieces of electrical wire (one long, one short)
Lamp switch wire including plug
Pivot join
Twist-on wire connector x2
Candelabra light bulbs x2
Clippers
Drill
Screwdriver
Light sockets (chandelier size)
Here’s how to make a phone lamp:
1. Open up the base of the phone and cut out the wires.
2. Take the phone caps off. Drill a smaller hole to start and then increase the size of your drill bit. This is where the lamp socket will go. Work to get the size just so.
3. Wrap the phone cord around a curved metal rod. We used a piece from an old lamp.
4. Strip the ends of your electrical wire and thread it through the lamp neck.
5. We recommend adding a pivot joint so that you can adjust the tilt on your phone lamp. This is optional.
6. Attach the lamp neck to the phone receiver.
7. Connect the electrical wire that runs thru the phone lamp neck to the first lamp socket. Also connect the second, smaller piece of electrical wire to the same lamp socket. Then thread this small piece of wire thru the middle of the phone receiver and connect it to the lamp socket on the other side.
8. Place the phone cap back on, and hold onto the socket as you spin to close the phone cap back into place.
9. Attach the lamp neck to the base of the phone and hold it in place with a hex nut. Use marrettes (called twist-on wire connectors in the UK) to attach the lamp switch to the electrical wire at the base of the phone lamp. Then close up the base of the lamp.
That’s it, you now have an awesome retro phone lamp!
Materials you need to make a phone lamp:
Retro telephone
Curved metal rod (we used an old lamp part) and hex nut
2 pieces of electrical wire (one long, one short)
Lamp switch wire including plug
Pivot join
Twist-on wire connector x2
Candelabra light bulbs x2
Clippers
Drill
Screwdriver
Light sockets (chandelier size)
Here’s how to make a phone lamp:
1. Open up the base of the phone and cut out the wires.
2. Take the phone caps off. Drill a smaller hole to start and then increase the size of your drill bit. This is where the lamp socket will go. Work to get the size just so.
3. Wrap the phone cord around a curved metal rod. We used a piece from an old lamp.
4. Strip the ends of your electrical wire and thread it through the lamp neck.
5. We recommend adding a pivot joint so that you can adjust the tilt on your phone lamp. This is optional.
6. Attach the lamp neck to the phone receiver.
7. Connect the electrical wire that runs thru the phone lamp neck to the first lamp socket. Also connect the second, smaller piece of electrical wire to the same lamp socket. Then thread this small piece of wire thru the middle of the phone receiver and connect it to the lamp socket on the other side.
8. Place the phone cap back on, and hold onto the socket as you spin to close the phone cap back into place.
9. Attach the lamp neck to the base of the phone and hold it in place with a hex nut. Use marrettes (called twist-on wire connectors in the UK) to attach the lamp switch to the electrical wire at the base of the phone lamp. Then close up the base of the lamp.
That’s it, you now have an awesome retro phone lamp!
via upcyclethat
Related Posts
Subscribe Our Newsletter
0 Response to "DIY Phone Lamp"
Post a Comment